YT6800 Yamaha Drive Pulley

[taxman01]

Any & all info for getting the main drive pulley off the crankshaft is greatly appreciated. I have tried a 2jaw puller & a 3jaw puller. No luck. Anyone know how to get this off? Any tricks of the trade? Or any secret yamaha tools?
Let me know please, Taxman01

[YamaDog]

Not sure how it is secured on there but if a pulley is just stuck on a shaft use your puller and when you have it tight take a hammer and hit the puller center bolt tighten again and repeat until it breaks loose

[Rdnckrick]

Any have any tricks for this? I have a stubborn one as well

[cr250]

They just slide on, so I would try some penetrating oil.

[Rdnckrick]

Man I don't get it.  I've tried two 3-arm pullers and went and bought the M14-1.5 bolt to thread into the center with no luck.  Tried heat and penetrating oil.  I'm ready to cut the darn thing and try and figure out a new pulley after.