Yamaha Rear Bagger Model GC 38 A For Sale

[bdawg8569]

I have a Yamaha Rear bagger that i'd like to sell. I don't know what tractor(s) it may fit. I got it with some stuff at an auction, but the person must have gotten rid of the Yamaha tractor or something. The tag on it says that it is model #GC 38 A and serial # BB2 000500. I live in Granger, Indiana which is northern Indiana close to South Bend and the University of Notre Dame. I am asking 75 dollars for the bagger plus whatever it would cost to ship it if that's necessary. Greyhound bus would be the cheapest option i'm sure.

[Wayne1]

That is the same bagger model number as on my YT3600, so it will fit that tractor.  Don't know about the other Yamaha tractor models.

[Jeff S]

I'm somewhat close here in Ft Wayne, IN and interested, but I have a YT6800. Hmmm

I wonder how I can find out if this would fit?

[bdawg8569]

Wayne - Thanks for the info, I appreciate that.

Jeff - Ft. Wayne is about 1.5 hours from me, so yeah that's not too bad. However, i am not sure about whether this one would fit or not. Maybe i could give you some rough measurement of where the bagging system attaches to the deck and see if that's even close to what you have on your tractor.

[Jeff S]

yeah sounds good


thanks, Jeff

[bdawg8569]

Here are some pics with the measurements i took. Maybe these can help you make an educated guess.

[Jeff S]

Thanks, those measurements should help me see if it could fit. However, I will still need the bracket where it mounts to the back of the tractor. Unless you happen to have that? I think it is like a slip in receiver and the bagger slides down into the mount.

[bdawg8569]

Hey Jeff,
   Sorry for the slow reply. Busy weekend. Unfortunately I do not have the part that attaches to the tractor. I didn't even think about that piece. That was probably left on whatever tractor this bagging setup was used on. I think you could probably make something that would work though if you think that the bagger will work to attach to the deck. You know how to weld or know anybody that does?

[Jeff S]

yeah i do have a welder and probably could make a mount.  May try to see if I could pick it up this weekend if possible.

[ATC83]

Is this bagger still for sale I'd be very interested in it if it is. Let me know.
Thanks, Christian

[bdawg8569]

No, Sorry I did sell it.